Today I’ll finish off connecting the wires to the starter and clean out the braided fuel lines to make sure there isn’t any anti-seize left in the lines from the fittings. I should be able to also snug up the orb ends in the Y-block and the Fuel Pressure Regulator.
I’ll try and get the PS pump installed and run the P&L braided PS feed line. While I’m waiting for my intercooler pipes to be finished, I’ll turn some of my focus to the trunk.
You can see some of the progress that I’ve made there as well. After I get the two enclosures sealed, I’ll connect them together so that there isn’t a big gap between them.
And of course, they will be covered in Carbon Fiber too!!